Relex Software Training Facility 3 Pineview Place 245 Humphrey Road Greensburg, PA 15601 Phone 724.836.8800 Fax 724.836.8844

From the Pittsburgh International Airport (PIT)

1. Take Route 60 East towards Pittsburgh.
2. You will pass through the Fort Pitt Tunnel. After exiting the tunnel you will be on a bridge with Pittsburgh ahead of you. Take a right on the far side of the bridge onto Route 376 East, towards Monroeville.
3. Follow Route 376 East through the Squirrel Hill Tunnel and continue to Monroeville.
4. At Monroeville, take a right onto the Pennsylvania Turnpike (Route 76) heading East.
5. Take a right turn after picking up your ticket at the tollbooth.
6. Take the first exit at Irwin, Exit 67 (Old Exit #7), from the Pennsylvania Turnpike (The toll charge is $1.00).
7. After leaving the tollbooth at the Irwin exit, take a right onto Route 30 East towards Greensburg and go approximately 10-11 miles.
8. Exit Route 30 at the Route 130 Pleasant Unity exit.
9. Take a left at the traffic light onto Route 130.
10. After ~0.5 miles, turn right into Pineview Place (Humphrey Road).
11. The Relex Training Facility is in the lower level of building 3 (lowest building).
12. Please enter through the left-most door of the lower level of building 3.

From Philadelphia and East

1. Take the Pennsylvania Turnpike (Route 76) Turnpike West to New Stanton, Exit 75 (Old Exit #8).
2. After exiting the tollbooth, take Route 119 North (following signs to Greensburg) for several miles.
3. After passing Hoss's Steak House on the right, turn left at the traffic light onto Route 30 East.
4. Stay on Route 30 East for ~1.0 mile.
5. Exit Route 30 at the Route 130 Pleasant Unity exit.
6. Take a left at the traffic light onto Route 130.
7. After ~0.5 miles, turn right into Pineview Place (Humphrey Road).
8. The Relex Training Facility is in the lower level of building 3 (lowest building).
9. Please enter through the left-most door of the lower level of building 3.

From the Relex Software Corporate Headquarters to the Relex Software Training Facility

1. From the Relex Software Corporate Headquarters parking lot, turn left onto Pellis Road.
2. Proceed on Pellis Road and turn left onto Route 130.
3. Take Route 130 for ~0.5 miles and turn right into Pineview Place (Humphrey Road).
4. The Relex Training Facility is in the lower level of building 3 (lowest building).
5. Please enter through the left-most door of the lower level of building 3.